3D Touch probe sensor for auto leveling

3D Touch probe sensor for auto leveling

0 reviews 5 sold. Only 0 remain
17.01€
Ex Tax: 13.94€
Product Code: 220569
Availability: Out Of Stock
Viewed 696 times

Product Description

Automatic 3D Touch calibration sensor for more accurate Z-axis measurement with heating table.

The measurement is point-by-point and thus works on any basis.

Specifications:
Voltage: 5V
Current: 15mA
Cable length: short 200mm / long 1000mm
3pin: Green (-, GND) / Red (+ 5V) / Orange (signal)
2pin: Black (-, GND) / White (Zmin)

Check the printer control circuit documentation for the correct connection.

In the package: 1x sensor with cables

Write a review

Please login or register to review

Cookie Preferences

These cookies are required for the website to run and cannot be switched off. Such cookie are only set in response to actions made by you such as language, currency, login session, privacy preferences. You can set your browser to block these cookies but our site may not work then.

Analytics & Statics

These cookies are usually set by our marketing and advertising partners. They may be used by them to build a profile of your interest and later show you relevant ads. If you do not allow these cookies you will not experience targeted ads for your interests.

Marketing and Retargeting

These cookies allow us to measure visitors traffic and see traffic sources by collecting information in data sets. They also help us understand which products and actions are more popular than others.